[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Garden Ridge TCA Layout



FYI  - Our Austin commitment is at the AMTRAK Station just off of Lamar Blvd.

250 N Lamar Blvd, Austin, TX ‎

(800) 872-7245 ‎ 

 

I think Rick is doing the setup at 6pm tonight (5/9/14). Running train(s) Saturday.

 

Paul

 

From: Paul & Gayle [mailto:calmes@earthlink.net]
Sent: Friday, May 09, 2014 1:11 PM
To: 'ttat-members@aoot.com'
Subject: RE: Garden Ridge TCA Layout

 

Don,

 

I-35 South right on Hwy. 3009 – Natural Bridge Cavern Road  (west). Then a right on Municipal Pkwy.

It’s next to City Hall & Police Station

9400 Municipal Parkway

San Antonio, TX 78266

(210) 651-6632

 

 

Setup at 5pm tonight. Run trains 9-4 Saturday. Teardown 4-6pm.

 

Paul Calmes

 

From: ttat-members-owner@aoot.com [mailto:ttat-members-owner@aoot.com] On Behalf Of don448@aol.com
Sent: Friday, May 09, 2014 12:53 PM
To: ttat-members@aoot.com
Subject: Re: Garden Ridge TCA Layout

 

Rick,
     Looking for a Garden Ridge address to plug into my GPS.  Do you have it?

Thanks,

Don

 

 

 

-----Original Message-----
From: rick <rbd1949@aol.com>
To: ttat-members <ttat-members@aoot.com>
Sent: Thu, May 8, 2014 8:26 pm
Subject: Re: Garden Ridge TCA Layout

As you know, layout space has always been up in the air until we arrive.  L-shapes were built after determining that they would fit.  every year has been the same way.  rumor has it that Jason will be there as well.  I personally like L-shapes but it all depends on space and manpower.  I'm sure whatever y'all set up will look good and work well.  Model Railroading is Fun!! 

 

 

 

-----Original Message-----
From: Bill Lohman <844bill@gmail.com>
To: ttat-members <ttat-members@aoot.com>
Sent: Thu, May 8, 2014 6:34 pm
Subject: Re: Garden Ridge TCA Layout

Ira,

 

All I know is -- we did L shaped layouts in 2010 and 2011 at Garden Ridge and everybody seemed to enjoy them and they fit the space.  If we're getting less space and only a 6 X 2 with 90 degree corners will fit then so be it.  Just trying to help.  

 

As for your  statement, "you apparently don't understand the geometry of layouts."  I admit to being part of the "great unwashed."   After all, all I have is bachelors and masters degrees in engineering.  So, a topic as complex as layout geometry is probably beyond my abilities.  Thankfully, we have you to carry this heavy burden.  And thanks for the lesson.

 

See ya' at setup

Bill