I mentioned the 4 TPC limitation at the Legacy users gorup in York. I
gave Steve an email to inquire about a solution. I will use information
provided by Ira to inquire about the club's issues too.
Thanks for the offer. I have it under control. But, you're
always welcome over here.
I saw an OGR post within the last couple of days citing a 4 TPC limit on
Legacy. I understand that the DZ-2001 unit may have an impedance mis
match with the TPC inputs and may be hogging the signal or rather attenuating
it for the TPC's. But, just thought I'd mention the posting I saw.
Is the cabling a daisy chain, series topology or a star topology to all five
devices?
Are you planning on going to the May 15 TCA show in Garden
Ridge?
On Tue, Apr 27, 2010 at 11:22 AM, Steve Wise
<swise@aoot.com>
wrote:
Bill Lohman wrote:
Hi Steve,
You're welcome to load v1.3 using
these modules if you wish. I was under the impression that you're
not using Legacy?
I intend to use Legacy again
once I resolve the issues with driving 4 TPCs + the Z-stuff DZ-2001 unit.
As for being registered. When I received my
Legacy with the Big Boy as a package deal there was a note in the box to
be sure and register to receive the modules. So, I did and I
received a set. I wouldn't count of them putting you on the list
because of a repair. I'd call them.
Ok
I'll call them.
BTW am working on double tracking the front corner
by the entry door. This will give me two independent loops -- the
upper one with sidings and the inner loop that goes down through the
valley and then back along side the upper one with two crossovers on the
engine terminal side. Big job as is. The total double tracking
was just not practical.
Sounds fun! If you
want help, hollar!
CU
Stevo.
------
TTAT members
reflector.