Re: Lift out bridge

[scott a smiley <sc.smiley@juno.com>]

One of the best things about thinking and planning is that it does not
cost anything until we know it will work and be beneficial..  Thanks for
the offers Bill.  Home Depot Arbor walk has some cut 3/4'" plywood for $2
that might also be good.  In their scrap bin.  

Scott

On Thu, 4 Jun 2009 09:44:57 -0500 Bill Lohman <844bill@gmail.com> writes:
> I agree with Adrian and Steve.  It would be extremely useful during 
> setup
> and teardown.  And would give us a more user friendly and better 
> defined
> entrance/exit during the show hours.  Bet it would save valuable 
> time during
> setup -- and some aching backs on us geezers.
> 
> I have three each 28" wide by 4 feet long sections of 1/2 inch 
> plywood left
> over from building the 45 degree corners.  Also enough "already 
> ripped to
> club size" 1 by 3's  eight feet long to build three standard linear
> modules.  And all the wire and jones plugs we would need.  And I 
> still have
> a half gallon of "club approved" green paint. And I have enough foam 
> roadbed
> like we used on the 45 degree corners to do a 4 or 5 track linear 4 
> ft
> module.   And I can spare 4 ft of velco roll which I recently 
> purchased for
> other projects.
> 
> If the approved design would work out so we can use this material, 
> I'll
> gladly donate it to the club.  All we would need is track and 
> pocket
> hardware at the club's expense.  And maybe some other items needed 
> to do a
> nifty job on the lift out.  Bet we could build it for under $100 
> plus track=
____________________________________________________________
Criminal Lawyers - Click here.
http://thirdpartyoffers.juno.com/TGL2141/fc/BLSrjpTOVoLKNZFzdDRNQKyLPDfnh9penlrl2pUPSxeEKnGeY8h4VvOlcSc/