Plain Accessory Modules

["Ira Schneider" <ira_schneider@iname.com>]

I am donating the two Plain Accessory Modules that I built to the club.

One of these modules is stored in the trailer.  Until there is room in the trailer for the second module
I will keep it at my home and bring it to show runs.

These modules are basically blank 4'x1' modules that can be attached inside the layout next to any
mainline module.  These modules have 6-pin Jones plugs/sockets that attach between any two mainline modules
to provide power for the accessories from the Gray (16 volt) and Blue (10 volt) accessory circuits.
The modules have a set of RCA phono jacks to connect accessories to the power.  There are some
2-1/2' wires with RCA phono plugs in the Accessory Power Box for use with these modules.

At the GATS show, these modules held my Carousel, Ferris Wheel, Lionel Aquarium, and Operating
Drive-In Diner and Adrian's Greyhound Bus Terminal and Grocery Store.  These modules were designed
to hold any large accessories similar to these.  They can be used at any show by any member who
wants to display large operating accessories.  The space on these modules should be allocated by
the setup Fat Controller before the show.


Ira